Smart Home Energy Savings: What Really Cuts Your Bill

Smart thermostat on a coral accent wall

Namorra team |

A smart home can lower your energy use, but the size of the saving depends on which devices you install and how you set them up. A U.S. Department of Energy report found total site energy savings of 7% to 35%, or $123 to $670 a year, depending on location and how the household behaves. The thermostat does most of the work. Plugs, power strips and lighting add smaller gains, and good settings decide whether you get them.

Namorra
namorra.com
Make Smart Lighting Part of Your Setup
Explore Namorra’s curated selection of smart home products, including smart lighting, for practical ways to support everyday energy savings.
Explore smart home products

TL;DR

  • Realistic savings range from single digits to about a third of home energy use, depending on climate, house and habits.
  • A smart thermostat delivers the largest share of the savings. ENERGY STAR puts the average at 8% of heating and cooling costs.
  • Smart plugs and power strips cut waste from devices that sit idle, and they are the cheapest place to start.
  • Every connected device draws a little standby power, so choose devices that replace a real waste, not ones that only add features.
  • Schedules, away modes and time-of-use rates matter as much as the hardware.

Table of Contents

How much can a smart home actually save?

Headlines promise 30% to 40% savings. Entergy states that smart homes use an estimated 30–40% less energy on average, and also says the figure falls depending on how the technology is used. Independent modeling gives a more careful range, and that is the one to plan around.

Here is what the better-documented studies found:

Source What it measured Result
U.S. DOE/OSTI report, 2021 ENERGY STAR smart home energy management systems, modeled 7% to 35% site energy savings; $123 to $670 a year in bills
NLR foresee system Home energy management software 5% to 12% whole-home energy cost savings
ACEEE, 2018 Smart technology for every major end use, nationwide Up to 17% sector-wide
ENERGY STAR Certified smart thermostat 8% of heating and cooling costs, about $50 a year, for the average home
Peer-reviewed study in Energies, 2020 125 households with smart plugs and energy education over 15 months Around 5% less energy than average households

The spread is wide because homes differ. A house in a mild climate with an efficient furnace has less to save than one with a big heating bill and no schedule. The same goes for people: a household that already turns things off gains less than one that never does.

A useful way to read the table: expect something in the 5% to 15% range for a sensible setup, and treat the high end as the reward for pairing several devices with good habits.

How much can a smart home actually save?

Start with the thermostat

Heating and cooling are the biggest energy users in most homes. ENERGY STAR notes that the average American household spends over $900 a year on heating and cooling, so that is where a percentage saving is worth the most dollars.

The DOE modeling backs this up: the smart thermostat accounted for most of the savings in a home energy management system. ACEEE reports that smart thermostats have reduced heating costs by 8% on average and cooling costs by 10%.

Smart thermostats save in three ways:

  1. Schedules that match your life. The house eases off when nobody needs it conditioned.
  2. Geofencing. ENERGY STAR explains that smart thermostats monitor and adjust temperature and use geofencing to ease off heating and cooling when the home is empty.
  3. Zoned sensing. An ASHRAE Journal case study of a home with a single-zone system added a smart thermostat and seven wireless sensors. It recorded measured savings of 37.9% and a payback of about one year on a $586 cost. That is one house, not a promise, but it shows what good sensing can do.

Who gains the most

The gain depends on where you start. Entergy points out that if you had a non-programmable thermostat, switching can bring impressive savings. If you already had a programmable model that you adjusted regularly, the change will be smaller. In that case the smart features you add, such as remote control, away detection and usage reports, are where the extra value lies.

The same page notes that older homes with single-pane windows, thin insulation or gaps under doors waste heat that no thermostat can recover on its own. Sealing and insulating pairs well with a smart thermostat: the thermostat decides when to run the system, and the envelope decides how long the heat stays in.

Wiring check before you buy

Many thermostat installs stall on wiring. If your old thermostat has no common wire, read our guide to a thermostat without a C wire for your options and a safe setup before you start. Switch off power at the breaker before touching any wires.

Smart plugs and power strips: the cheapest first step

Much of the electricity in a home goes to devices that are on but not in use: game consoles, TVs, chargers, printers, desktop setups. ACEEE says smart outlets, smart plugs and advanced power strips can cut power to devices not in use, and that plug load savings can reach up to 50% in some households.

ENERGY STAR actually recommends starting with smart plugs for small appliances, then certified smart lights, then a certified smart thermostat. The logic is cost: plugs are inexpensive, easy to install and let you see where your habits waste power.

Good places for a smart plug or smart strip:

  • Entertainment centers. Put the TV, soundbar and console on one strip with a schedule that cuts power overnight.
  • Home office. Monitor, printer and charging dock can switch off when you leave for the day.
  • Seasonal appliances. A space heater or window fan on a plug with a timer stops it from running after you have left the room.
  • Garage and workshop chargers. Battery chargers rarely need to run all day.

The Energies study of 125 households found that savings rose when more appliances were connected and monitored more frequently. In practice: do not plug in one lamp and call it done. Cover the biggest idle loads and check your usage regularly.

Smart lighting: where savings come from

Lighting is a smaller slice of the bill than heating and cooling, but it is easy to improve. ACEEE says smart lighting has the potential to save 7–27% of a home’s lighting energy use.

The DOE modeling adds nuance. It found smart lighting did not save a significant amount when efficient LEDs with no standby power were the baseline. The practical lesson is that efficient LEDs do the heavy lifting, and smart control adds value when it keeps lights from burning in empty rooms. So pick LED lighting, then add timers, scenes, dimming and motion sensing where lights are most often left on.

Some examples of the control that helps:

  • Motion-activated lighting in hallways, closets, stairwells and wardrobes, where lights come on only when you need them. Our rechargeable motion-sensor light is built for exactly those spots.
  • Scheduled or app-controlled lamps in bedrooms and living rooms, so you can switch off from your phone after you are in bed. A G-shaped LED smart lamp with app control does this and doubles as ambient light.
  • Dimming and scenes that run a room at lower brightness in the evening.

Ceiling fans as a cooling helper

A fan moves air so you can feel cooler at a higher thermostat setting. Pairing a fan with schedule and app control makes it easier to run only when someone is in the room. Our Smart Ceiling Fan Light Pro combines a fan and a light with WiFi app control, so one device covers both jobs and can be switched off from your phone.

Smart Ceiling Fan Light Pro

Does a smart home use more electricity?

Sometimes a device costs more energy than it saves, so this deserves a straight answer. Australia’s government energy site says that although standby power of smart devices can be substantial, the savings generally exceed the extra energy they use. The savings only win when devices do useful work.

What the research shows about standby draw:

How to choose devices well

These findings point to simple buying rules:

  1. Buy for a job. Ask what waste the device removes: heating an empty house, a lamp left on, a console on standby. If you cannot name one, the device mainly adds load.
  2. Look for ENERGY STAR certification on thermostats, lights and plugs where it is offered. The EPA announced in January 2023 that Samsung’s SmartThings Energy was the first mass-market smart home energy management system to earn ENERGY STAR certification, with standby limits on all required devices.
  3. Prefer fewer, better-placed devices. One thermostat, a few strips on the biggest idle loads and smart control in the rooms where lights stay on beats a house full of gadgets.
  4. Put high-use devices first. A device that runs all day while controlling something you rarely use is the worst case.

Settings and habits that make the savings real

Hardware gets the attention, but behavior accounts for much of the result. The DOE report found that over half of the difference between an engaged smart home user and a non-energy-conscious household comes from simply being a very energy-conscious user. In other words, the devices make good habits automatic, and the habits are what pay.

Settings worth setting up in the first week:

  • Thermostat schedule. Set a setback for sleeping hours and for when the house is empty. Turn on geofencing so the system responds when you actually leave.
  • Plug schedules. Cut power overnight to entertainment and office gear.
  • Lighting automation. Motion on in low-traffic areas, timers on lamps, and an all-off scene at bedtime.
  • Usage reports. Check the app monthly. A device nobody looks at is easy to forget.

Use time-of-use rates

If your utility offers time-of-use pricing, automation gets more valuable. The Australian Government notes that savings increase on a flexible time-of-use tariff, because automated appliances avoid peak prices and use cheaper off-peak rates. In the U.S., the NLR says its foresee system shifts appliances to off-peak times, which can lower bills through existing demand-response and time-of-use programs. Check with your utility to see which programs it offers.

A home energy management system can also help. The Australian government describes how a HEMS can record electricity flow, shift high-energy equipment away from peak times and suggest the best times to run equipment. It is a bigger step than plugs and a thermostat, and it suits households with solar, an electric vehicle or a time-of-use plan.

Our perspective

We pick products for daily use, and that shapes how we think about smart home energy savings. The biggest gains rarely come from one dramatic gadget. They come from small devices that fit into routines you already have: a lamp you can switch off from bed, a hallway light that only comes on when you walk in, a fan and light you control from your phone.

That is why we curate smart home products around everyday convenience. A device that is easy to set up and pleasant to use is a device that stays in use, and the savings only count if you keep using it. We also think a smart home should start small. Choose the rooms where lights burn longest or where you run a fan, add control there, and build outward as you see what works.

Our smart home range is designed to make that first step simple, with app-controlled lighting and fan-and-light combinations that help you control when and where energy is used.

Namorra

Smart lighting and cooling from Namorra

If you want to begin with the rooms where control is easiest, our smart home collection covers app-controlled lamps, motion-sensor lights and a WiFi ceiling fan with light. They are designed to give you control of the lights and airflow you use most, from your phone or by motion.

Smart Ceiling Fan Light Pro

Browse the full Namorra smart home range, or go straight to the Smart Ceiling Fan Light Pro if you want one device that handles both lighting and airflow.

A simple order to build your setup

If you are unsure where to begin, follow the order ENERGY STAR suggests and adapt it to your home:

  1. Smart plugs on idle loads. Low cost, immediate. Start with entertainment and office gear.
  2. Efficient, controllable lighting. Use LEDs, then add schedules or motion sensing in rooms where lights are often left on.
  3. A smart thermostat. The largest single saving for most homes. Check your wiring first.
  4. Weatherization. Seal gaps and add insulation so the heating and cooling you pay for stays inside.
  5. Rate-aware automation. Once you have the basics, use time-of-use pricing and a home energy management system if your utility supports it.

Track your electric bill for a few months before and after each step. That gives you your own number instead of an average from a study.

FAQ

How much energy does a smart home save?

A realistic range is about 5% to 15% for a typical setup, and up to about a third in the best modeled cases. The DOE modeling found 7% to 35% site energy savings depending on location and behavior. The thermostat contributes most of it.

Are smart homes good for saving power?

Yes, when devices are chosen to remove real waste. The Australian Government says correctly implemented smart homes can save energy and money and also improve comfort. Devices that only add features do not deliver the same result.

Does a smart home use more electricity?

Each connected device draws a small amount of standby power, but the savings generally exceed it when the device controls a meaningful load such as heating, cooling or idle electronics. Devices like smart speakers and cameras add use without cutting any, so weigh them as conveniences.

Which smart device should I buy first to save energy?

ENERGY STAR suggests starting with smart plugs, then certified smart lights, then a certified smart thermostat. If your heating and cooling bill is large, you may want to move the thermostat up the list, since it delivers the biggest share of savings.

Will a smart thermostat save money if I already have a programmable one?

The gain may be smaller. If you adjusted a programmable model regularly, you already capture much of the saving. Features such as geofencing and sensors can still help when your schedule is irregular. Entergy’s guidance is that the change may be small in that case.

Sources